WINOMO Funny Car Stickers - High Gas Consumption Decal - Fuel Gauge Empty Vinyl Stickers (White) - Perfect for Car Windows, Laptops & Water Bottles - Express Your Humor on the Road

I read several reviews from people who had trouble getting the sticker to stay on the correct side of the sheet when they peeled the 2 sheets apart and of people who had trouble getting some parts of the sticker to come off the sheet onto their vehicle. I hesitated but, decided to buy it. I chose this higher priced sticker because it had less complaints than other sellers' stickers.I very s-l-o-w-l-y began separating the 2 sheets at the corner by the head. The top of the head was staying on the wrong sheet. I immediately pressed the sheets back together. I then placed the entire thing on a flat surface with the sheet the sticker is supposed to stay on facing up (actual sticker was facing up). Using my finger (not fingernail), I rubbed over all the parts of the sticker while applying pressure. I paid close attention to the smaller parts of the sticker like the teeth. I did this for several minutes. I left the sticker overnight, too dark outside now to put it on. The next morning I s-l-o-w-l-y peeled the sheets apart and the sticker was staying on the correct sheet until 1 of the gas level lines was staying on the wrong sheet. I mashed that area only of the sheets back together & applied pressure for a few seconds to that piece of the sticker like I had done the night before. I s-l-o-w-l-y started peeling the sheets apart from a different corner. As the sheets separated the sticker stayed on the correct sheet without a problem. I was really careful when I got to that 1 gas level line that gave me trouble but, it stayed on the correct sheet this time.Using cotton balls, I cleaned my entire gas tank door with 70% isopropyl alcohol and made sure it was completely clean and dry. I then put the sticker in place. Using my finger (not fingernail) I rubbed the sticker, applying pressure as I went, on the door for a few minutes. I only rubbed over the sticker, not the empty areas of the sheet. I paid particular attention to the small pieces of the sticker. I s-l-o-w-l-y peeled away the sheet and VOILA!. I love the way this looks on my Cherokee and would buy it again if I had another gas tank door. I did notice 2 small bumps/lumps/air pockets on the sticker. I must have left residual cotton ball on the gas tank door. It doesn't bother me though. They are so small.I will say that this sticker is thin compared to vinyl stickers I have purchased on Amazon. That may be why there is a bit of a problem with getting it to peel properly. My advise is to be patient and go s-l-o-w. If the sticker does not peel properly, stop peeling, do what I did and apply pressure...and be patient. Don't just throw it in the trash right away.